POWER TRAIN - FRONT PTO Mechanical 7. With both bearing caps removed, tilt the universal joint (1) on end and remove it from the yoke. NOTE: During manufacture of the yoke, excess material may have been added to the inside of the bearing cap bore (2) . This material can make removal of the universal joint difficult. It is acceptable to file this material away from the yoke to improve the removal of the universal joint. 8. Check to see if the universal joint bearing caps have adequate grease. If grease is needed use a extreme temperature, extreme pressure lithium base grease. 20034661B 7 9. Be sure the OD of the bearing caps are clean and free of rust.
Lightly lubricate the bores of the yoke with grease. Use a press and a solid plug to install a bearing cap (1) into the yoke bore (2) about halfway. Install the cross into the yoke and fit the cross trunnion into the partially installed cap. Make sure that all the needles of the bearing cap are aligned by rotating the cross in the cap. 20034660B 8 10. Install the bearing caps (1) onto the open trunnions that fit into the mating yoke. This will protect the trunnions from accidental damage during assembly of the universal joint. 20034664B 9 9682 1 27/05/2004 C.42.B / 7