Case IH AFX8010 — FRONT PTO Mechanical

POWER TRAIN - FRONT PTO Mechanical 7. Place the crown gear (1) on the bearing. 10040111A5 7 8. Place the output shaft (1) in the crown gear (2) using a mallet. Place the bearing (3) on the output shaft. 10033807A5 8 9. Place the O-ring on the cover (1) . Place the cover (1) on the gearbox. Install the M10x35 bolts and lock washers on the cover. Torque to 44 - 49 Nm ( 32.5 - 36.25 lb ft ). Install the outer race of the bearing, shims, spacer and the snap ring. Adjust number of shims to remove any play of the shaft. 10. Check the gear backlash using a dial gauge. Add or remove shims under the crown gear as necessary to achieve a backlash of 0.15 - 0.25 mm ( 0.006 - 0.010 in ).

10040112A5 9 10040113 10 9682 1 27/05/2004 C.42.B / 19