TRAVELLING - FRONT AXLE 5. Install Sun Gear (2) in output gear (1) . IMPORTANT: Both output and Sun Gears are marked. Marks must be aligned. zda4355a 4 6. Install retaining ring (1) . zda4356a1 5 7. Install bearing cup (2) in the housing (1) . Bearing cup must be fully seated in housing in the outer final drive housing. Install seal (3) in outer housing (1) . zda4636a 6 8. Apply oil to the seal and to the output shaft where the seal makes contact. Install final drive outer housing (1) on pre-assembled output shaft (2) . zda43572 7 9686 1 27/05/2004 D.10.A / 26