TRAVELLING - SERVICE BRAKE Hydraulic SERVICE BRAKE Hydraulic - Bleed (D.30.C - F.35.A.25) AFX8010 To bleed brakes, proceed as follows: 1. Block the wheels adequately to prevent runaway of the combine. 2. Raise the header and engage the header safety latch. Stop the engine. NOTE: As the brake pedals must be depressed several times while bleeding, this job has to be done with two persons. 3. Bleed the left- hand side circuit. 4. (Remove rubber caps from the left-hand side bleed screws, (1) . Slide a transparent hose over bleed screw (1) to catch the oil while bleeding. Open bleed screw (1) and depress the left-hand side brake pedal until fluid escapes. Close bleed screw (1) . ZDA5221A 1 5.
Depress the left-hand side brake pedal several times to build up pressure. Keep the pedal depressed. Open bleed screw (1) slightly to allow air and fluid to escape. Close bleed screw (1) and release the brake pedal. 6. Repeat step 5 until fluid free of air bubbles escapes through screw (1) . 7. Remove the transparent hose from bleed screw (1) and install the rubber cap. . 8. Bleed the right-hand side circuit. 9. (Remove rubber caps from the right-hand side bleed screws, (2) . Slide a transparent hose over bleed screw (21) to catch the oil while bleeding. Open bleed screw (2) and depress the right-hand side brake pedal until fluid escapes. Close bleed screw (2) .
ZDA5221A 2 9690 1 27/05/2004 D.30.C / 4