Case IH AFX8010 — PARKING BRAKE Hydraulic

TRAVELLING - PARKING BRAKE Hydraulic Parking brake override - Static description (D.32.C.59 - C.30.A.20) AFX8010 If it is not possible to release the parking brake electrically, it can be released hydraulically . To release the parking brake hydraulically, proceed as follows: (NOTE: The hydraulic override is the preferred method to safely override the parking brake. If the hydraulic method fails, the brakes can be released mechanically using great care.) 1. Raise the header and engage the header safety latch. Stop the engine. 2. Block the wheels adequately to prevent runaway of the combine. (NOTE: It is critical the machine be blocked safely ) 3.

A tow valve is located behind the trim panel between the front ladder deck and the grain tank. This valve allows manual release of the bark brake using hydraulics. Block the combine front to rear. Turn key switch to on position. Turn park brake to off position. Alarm will come on saying park brake is not engaging. To operate, turn knob (1) to the detent position. Use hand pump (2) to release park brake (approximately 60 pumps). Return valve (1) to the detent position to set park brake and for normal operation. Park brake is fully released when park brake lamp on shaft speed monitor goes off. 50031294z 1 4. To release the park brake manually if the hydraulic method fails proceed as follows:

5. Remove safety plate (20) and rubber boot (11) . ZDA5080A 2 6. Remove cotter pin (2) and rotate nut clockwise (3) until the parking brake piston is completely pulled backwards to release the pressure on the parking brake disc. ZDA4707B 3 9691 1 27/05/2004 D.32.C / 6