Case IH AFX8010 — USER PLATFORM

BODY AND STRUCTURE - USER PLATFORM B -- LEFT FRONT SPEAKER CIRCUIT TEST E.34 / 38 Test Point Good Reading Possible Cause of Bad Reading 6 Measure for 12 volts at Fuse F11. 12 volts If good reading, repair open circuit 081 (OR) between Radio connec- tor X314 (Pin 7) and Fuse F11. Open circuit 081 (OR) between Fuse F11 and Accessory 2 Relay K03. Blown fuse F11 or Accessory 2 Relay K03. Refer to Power Distribution for Accessory 2 Relay K03 testing. 7 Key Ignition Switch S02 in “IGN” position. Mea- sure for 12 volts at Transceiver Outlet con- nector X141 (pin 2). 12 volts If good reading, go to test point 9. Open 083 (RD) circuit between Transceiver Outlet connector X141 (pin 2) and Fuse F13.

Check for connection at in--line connector X002 (pin11). Continue to next test point. 8 Measure 12 volts at Fuse F13. 12 volts If good reading, repair open circuit 083 (OR) between Transceiver Outlet connector X141 (pin 2) and Fuse F13. Blown Fuse F13. Open circuit 008 (OR) between Accessory 2 Relay K03 (pin 5) and Fuse F13. Refer to Power Distribution for Accessory 2 Relay K03 testing. 9 Measure resistance be- tween Transceiver Out- let connector X141 (pin 1). Less than 1 ohm If good reading, power and ground to Transceiver Outlet connector X141 (pin 1) are working properly. Open circuit 281 (BK) between Transceiver Outlet connector X141 (pin 1) and ground.

Test Point Good Reading Possible Cause of Bad Reading 1 Disconnect connector X315 from Radio A04. Measure resistance be- tween Radio A04 connector X315 (pin 6) and Radio A04 connector X315 (pin 5). Approximately 4 ohms. If good reading, Left Front Speaker H05 and wiring are okay. Open/short to ground in circuit 977 (WH) between Left Front Speaker H05 connector X136 (pin B) and Radio A04 connector X315 (pin 5). Open/short to ground in circuit 983 (BL) between Left Front Speaker H05 connector X136 (pin A) and Radio A04 connector X315 (pin 6). 2 Disconnect connector X136 from Left Front Speaker H05. Measure resistance be- tween Pin A and Pin B on the lead from the Speaker H05.

Approximately 4 ohms. If good reading, continue with next step. Broken wire from Speaker H05 to connector X136, either to Pin A or to Pin B. Broken solder connection at Speaker H05. Bad Speaker H05.