BODY AND STRUCTURE - ENVIRONMENT CONTROL Heating, ventilation and air-conditioning Expansion valve - Dynamic description (E.40.D.34 - C.30.A.10) AFX8010 The thermal expansion valve is on the pressure line leading from the drier/receiver into the evaporator. The valve changes the liquid refrigerant from high to low pressure without a change from liquid to vapor. A thermostatically controlled valve within the expansion valve body controls the volume of liquid refrigerant passing through the orifice and makes sure the refrigerant is fully vaporized within the evaporator by sensing the amount of superheat of the vapor leaving the evaporator. Liquid refrigerant would damage the compressor.
The valve responds to changes in the cooling requirements of the system. When increased cooling is required, the valve opens to increase the refrigerant flow. When less cooling is required, the valve closes and decreases the refrigerant flow. All of the needed temperature and pressure sensing functions are consolidated into this unit. No other external tubes are required for its operation. When the compressor is off, pressure, (system plus spring pressure), below the actuating diaphragm (1) is greater than the pressure above it. The metering ball (2) is held tightly against the seat by the spring, and no flow is present through the valve.
20036387A5 1 Upon initial startup of the compressor, the pressure drops rapidly in area (1) . The pressure above the diaphragm is now greater than that below. The actuating rod pushes down, unseating the ball and allowing refrigerant to flow to the evaporator. During operation, the pressure below the diaphragm will change and adjust valve position to maintain eight degrees superheat of the refrigerant flowing from the evaporator. 20036388A5 2 Temperature Sensor (1) , Ball and Spring (2) , To Evaporator (3) , From Evaporator (4) , To Compressor (5) , From Condenser (6) . 20036386A5 3 9702 1 27/05/2004 E.40.D / 8