TOOL POSITIONING - LIFTING A. If there is no voltage present on the wires, continue with Step 8 . B. If there is voltage on the wire, the short to voltage is in the main frame (MF) harness between connector X022 and connector X019 pin J2-20 wire 1117 black, 1118 black or 1114 black. Locate the short and repair. Continue with Step 8 . NOTE: The high voltage source may not be present as it may not be currently powered up. If the fault code typically appears when operating another circuit, activate that circuit while performing this check. 5.
The sense resistor in the module for the Header Raise/Lower Current Sense circuit is easily damaged as a result of excessive current draw or a short to high voltage. After locating the source of the problem and correcting, the module must be checked for damage. Carefully disconnect connector X019 from the bottom of the CCM1 module. Use a multimeter to check resistance between connector X019 pin J2-20 on the module and chassis ground. There should be less than 1 ohms resistance. A. If there is infinite resistance, the sense resistor in the CCM1 module has failed. Replace the module. B.
If the resistance is correct, the sense resistor in the CCM1 module is okay, and the circuit should function correctly. Continue with Step 9 . 6. Operate the combine while monitoring the Header Raise/Lower Current Sense circuit current on the Universal Display Plus "DIAG" screen. A. If no high out of range current readings are seen, erase the error code and continue operation. 9706 1 27/05/2004 G.10.A / 4