Case IH AFX8010 — TILTING

TOOL POSITIONING - TILTING Support - Install (G.20.A.77 - F.10.A.15) AFX8010 Prior operation: TILTING - Remove (G.20.A - F.10.A.10) 1. Lift the face plate into position and insert the pin (1) . Secure the pin with the bolt and washer (2) . Repeat on other side of feeder. Insert the carriage bolts and loosely install the washers and nuts (3) . Refer to TILTING - Check (G.20.A - F.45.A.10) to set the tilt angle based on the combine tire size. Torque the nuts (3) to 555 - 620 Nm ( 408 - 460 lb ft ) . 40032074B5 1 2. Disconnect the upper hose (1) from the hydraulic cylinder and install the cylinder on the face plate. Reconnect the hydraulic hose. Insert the pin, 2, and bracket, 3, and bolts.

Install the pin (4) . Hold in place with the bracket and bolt (5) . Set the hydraulic coupling and electrical connector on their mounts (6) on the face plate. 40032072A5 2 9707 1 27/05/2004 G.20.A / 5