Case IH AFX8010 — TILTING

TOOL POSITIONING - TILTING CCW). Repeat this resistance check between the front frame (FF) harness end of connector X019 pin J2-10 and connector X020 pin J3-2 (tilt CW). A. If the resistance is lower than the previously measured resistance, there is a short in the main frame (MF) harness between connector X008 and connector X019 wire 555 blue. Locate the short and repair. Continue with Step 8 . B. If the resistance is the same as previously measured, continue with Step 6 . 5. Key on. Disconnect connector X021 . Use a multimeter to check for voltage at connector X021 pin H or K (harness end). There should be no voltage on either wire. A.

If there is no voltage present on the wires, continue with Step 8 . B. If there is voltage on the wire, continue with Step 7 . NOTE: The high voltage source may not be present as it may not be currently powered up. If the fault code typically appears when operating another circuit, activate that circuit while performing this check. 6. Key on. Disconnect connector X008 . Use a multimeter to check for voltage at the main frame (MF) harness end of connector X008 pin 13. There should be no voltage. A. If there is no voltage present on the wires, there is a short to voltage in the front frame (FF) harness between connector X021 and connector X008 wires 553 blue, 554 blue or 555 blue.

Locate the short and repair. Continue with Step 8 . B. If there is voltage on the wire, there is a short to voltage in the main frame (MF) harness between connector X008 and connector X019 pin J2-10 wire 555 blue. Locate the short and repair. Continue with Step 8 . NOTE: The high voltage source may not be present as it may not be currently powered up. If the fault code typically appears when operating another circuit, activate that circuit while performing this check. 7. The sense resistor in the module for the Header Tilt Current Sense circuit is easily damaged as a result of excessive current draw or a short to high voltage.

After locating the source of the problem and correcting, the module must be checked for damage. Carefully disconnect connector X019 from the bottom of the CCM1 module. Use a multimeter to check resistance between connector X019 pin J2-10 on the module and chassis ground. There should be less than 1 ohms resistance. A. If there is infinite resistance, the sense resistor in the CCM1 module has failed. Replace the module. B. If the resistance is correct, the sense resistor in the CCM1 module is okay, and the circuit should function correctly. Continue with Step 9 . 8. Operate the combine while monitoring the Header Tilt Current Sense circuit current on the Universal Display Plus "DIAG" screen.

A. If no high out of range current readings are seen, erase the error code and continue operation. 9707 1 27/05/2004 G.20.A / 7