Case IH AFX8010 — TILTING

TOOL POSITIONING - TILTING Control valve Lateral tilt valve - Unidentified failure (G.20.A.13.20 - G.30.B.46) AFX8010 E0057-11 - Header Tilt CCW Valve Cause: The lateral tilt CCW valve (L-19) circuit is open, or shorted to ground. Possible failure modes: 1. Supply wiring damaged. 2. Bad solenoid. 3. Controller internal failure (internal regulator failure). Solution: 1. Enter the Universal Display Plus "DIAG" screen. Select the "HDR HEIGHT/TILT" sort menu, and select "TILT CCW VLV" to monitor the current flow. Use the "COMMAND" and "ENGAGE" functions to power the circuit at 100% output. The proper current is approximately 1.0 - 1.5 amps . A.

If the current reading goes to maximum, and then back to zero, the circuit is shorted to ground and the software has shut off the output to protect the module and wiring. Continue with Step 2 . B. If the reading is 0 amps , the circuit is open. Continue with Step 7 . 2. Disconnect connector X021 . Use a multimeter to check the resistance of the lateral tilt CCW valve coil (L-19) between connector X021 pins J & K. The proper resistance range is 3 - 5 ohms . C. If the reading is within the proper range, the circuit is working properly. Continue with Step 9 . A. If there is zero resistance, the lateral tilt CCW solenoid is shorted internally. Replace the solenoid. B.

If there is infinite resistance, the lateral tilt CCW solenoid is open. Replace the solenoid. C. If the resistance is correct, continue with Step 3 . 3. Use a multimeter to check for continuity between connector X021 pin J (FF harness side) and chassis ground. Flex the front frame (FF) harness while making this check. A. If there is continuity to ground, there is a short to ground in the front frame (FF) harness between connector X021 and connector X020 pin J3-1 wire 548 white. Locate the short and repair. B. If there is no continuity to ground, continue with Step 5 . 4. Use a multimeter to check for continuity between connector X021 pin K (harness side) and chassis ground.

Flex the front frame (FF) harness while making this check. A. If there is no continuity to ground, continue with step 8 . B. If there is continuity to ground, continue with Step 7 . 5. Use a multimeter to check for continuity between the main frame (MF) harness end of connector X008 pin 13 and chassis ground. Flex the main frame (MF) harness while making this check. A. If there is no continuity to ground, continue with step 6 . B. If there is continuity to ground, there is an open circuit in the front frame (FF) harness between connector X021 and connector X008 wire 553 blue or 555 blue. Locate the open and repair. 6. Carefully disconnect connector X019 on the bottom of CCM1 module.

Use a multimeter to check for continuity between connector X019 pin J2-10 on the module and chassis ground. 9707 1 27/05/2004 G.20.A / 13