TOOL POSITIONING - LEVELLING Support Tool support - Remove (G.30.A.77.77 - F.10.A.10) AFX8010 1. Remove the bolt (1) and plate (2) and remove the pin holding the position sensor arm in place. 40032068A5 1 2. Remove the bolt (1) and plate (2) and remove the pin holding the hydraulic cylinder in place. 3. Start the combine and tilt the head left to retract the cylinder out of the way. 40032069A5 2 4. Attach a lifting device (1) to the face plate. Remove the bolts (2) washers, spacers and nuts. Remove the two bolts (3) washers, center retaining plate (4) and thrust washer. Slide the face plate off the center pin and lower the face plate to the ground. 40032070A5 3 9708 1 27/05/2004 G.30.A / 3