CROP PROCESSING - FEEDING Feeder housing Drive system - Overview (K.25.E.40 - C.10.A.10) AFX8010 FEEDER DRIVE Wiring harness - Electrical schematic frame 15 (A.30.A.88 - C.20.E.15) The feeder drive system consists of electrical, electronic, hydraulic and mechanical components which work together to enable several different modes of operation. This may make diagnosing a feeder system problem quite difficult. To better explain how the feeder system operates, each mode of operation is explained from the moment of activation to the resulting action. The feeder drive has very specific operating requirements which may prevent the feeder from functioning properly.
The system is in control of all feeder operations, maintaining RPM, monitoring, troubleshooting and issuing warnings. FEEDER - MODES OF OPERATION Idle Immediately after the operator has started the engine, electrical power is applied to the CCM1 module and the feeder should be at rest. The CCM1 module receives signal from the Feeder Speed Sensor B-14 at connector X020 pin J3-14. Providing the detected feeder speed is below 5 RPM, current is sent from connector X020 pin J3-15 to energize the Ring-to-Frame clutch L-50. The Ring-to-Frame clutch L-50 is engaged to hold the feeder speed at zero.
Calibration This mode is accessible from the IDLE state, via the Universal Display Plus monitor, requiring operator initiation. Calibration is used to define minimum and maximum pump and Engine-to-Ring clutch coil current values. These values are stored in nonvolatile memory. Calibration should be done at least once every harvest season and immediately following pump or clutch replacement. Feeder Engagement When the operator places the feeder control switch S-31 in the forward detented position, the feeder will be started by activating an acceleration mode to start and bring the feeder up to the requested RPM.
The electrical system deactivate the Ring to Frame clutch L-50, and will activate the Engine-to-Ring clutch L-47 to start the feeder turning. The clutch will be modulated to provide smooth engagement, bringing the feeder speed up to the desired speed within 5 seconds. The electronics will monitor the actual feeder gear case output speed and make adjustments to the feeder pump as required to match the actual feeder speed to the requested feeder speed. Feeder Drive Control There are essentially three phases of the mechanical portion of the feeder system. Mechanical Power, Hydro Power, and Combined (Mechanical and Hydro) Power.
Mechanical Power - Mechanical Power is used during feeder startup and normal operation of the feeder. Power is directed from the engine through the PTO gearbox to drive the Engine-to-Ring, ring planetary carrier, feeder gearbox and feeder. This provides the main flow of power to operate the feeder. Hydro Power - Hydro Power is used speed control when in forward mode, and for reversing the feeder chain for clearing the feeder of debris. Power from the engine is directed through the PTO gearbox to drive the feeder hydro pump, drive motor, sun gear, planetary carrier, feeder gear box and feeder.
Combined Power - Combined operation of both the mechanical power and hydro power modes allows for speed adjustment of the feeder drive. Power from the engine is directed through the PTO gearbox to drive the Engine-to-Ring, ring, planetary carrier, feeder gearbox and feeder. The hydro pump and motor will control the speed of the sun gear to change the speed of the planetary carrier which drives the feeder. This provides for an Over-Speed or Under-Speed condition relative to the Engine and PTO gearbox speed. To engage the feeder in a forward direction, the following conditions must be met: 1. Rear ladder must be in the "UP" position. 2. Operator seated. 3.
Engine Running 9712 1 27/05/2004 K.25.E / 4