CROP PROCESSING - FEEDING Feeder housing Gearbox - Remove (K.25.E.44 - F.10.A.10) AFX8010 1. To remove the conveyor/rocktrap gearbox proceed as follows. 20034592 1 2. Remove the spline yoke bolts (1) and the bearing caps (2) at the upper gearbox. NOTE: The driveshaft may need to be pryed off the splined shaft. Be careful in doing so. 20034596A5 2 3. remove the spline yoke bolts (1) and the bearing cap bolts (2) from the lower gearbox. 20034594A5 3 4. Remove the drive shaft away from the feeder. 9712 1 27/05/2004 K.25.E / 25