Case IH AFX8010 — FEEDING Feeder housing

CROP PROCESSING - FEEDING Feeder housing Feed chain - Install (K.25.E.48 - F.10.A.15) AFX8010 DANGER M184D - ALWAYS shut OFF engine, remove the key and engage feeder safety lock in position on lift cylinder before working under header or feeder. Failure to engage feeder safety lock may cause injury or death. 1. Route a rope through the bottom of the feeder, around the feeder drive sprocket, and back out through the top of the feeder. Attach the bottom end of the rope to the new chain so that the taller edge of the feed slat is the leading edge. Pull the chain through the feeder. 2. When the chain reaches the rear of the feeder, place the chain on the teeth of the feeder drive sprocket (1) .

Manually rotate the feeder to assist in feeding the chain. IMPORTANT: Be sure that chains engage both rear sprockets evenly to assure the feeder slats are square to the cross shaft. 10032080A5 1 3. Connect both ends of the chain together with the connection links (1) . 10032078A5 2 Next operation: Adjust the tension as described in Feed chain - Tension adjust (K.25.E.48 - F.45.A.40) . 9712 1 27/05/2004 K.25.E / 45