CROP PROCESSING - THRESHING Axial flow threshing Drive system - Overview (K.40.C.40 - C.10.A.10) AFX8010 ROTOR DRIVE Wiring harness - Electrical schematic frame 17 (A.30.A.88 - C.20.E.17) The rotor drive system consists of electrical, electronic, hydraulic and mechanical components which work together to enable several different modes of operation. This may make diagnosing a rotor drive system problem quite difficult. This section will show how the threshing system components work together under normal operation. The rotor drive has very specific operating requirements which may prevent the rotor from functioning properly.
The system is in control of all rotor operations, maintaining RPM, monitoring, troubleshooting and issuing warnings. ROTOR - MODES OF OPERATION OFF The operator will have placed the separator engage switch S-30 into the OFF (center-detented) position, the rotor should not be powered and should be at rest. CALIBRATION The calibration mode provides the ability for the electronics to learn clutch fill times and current required to activate the rotor drive pump and clutch solenoids. Calibration is only accessible when the rotor is in idle state. Calibration is performed by using the Universal Display Plus monitor.
The status of the calibration process is displayed on the Universal Display Plus monitor. The rotor calibration process should not take more than 2-3 minutes to complete and should be re-calibrated as follows: 1. At least once per harvest season. 2. If the rotor pump coil L-40/41 or Engine-to-Ring clutch coil L-45 is replaced. 3. If significant operating and/or weather temperature changed since the last calibration. ROTOR ENGAGEMENT When the operator places the separator engage switch S-30 into the forward detented position, the rotor will be started by activating an acceleration mode to start and bring the rotor up to the requested RPM. Steps of Operation: 1.
The electrical system will activate the ring to frame brake L-46 and rotor drive pump to start the rotor turning. The electrical system will be monitoring the rotor drive motor speed sensor B-58 and rotor gear case output speed B-01 to determine what gear range the rotor gear case is in and to determine when the rotor is at approximately engine drive RPM. 2. The electrical system will deactivate the ring to frame brake L-46 and engage the engine to ring clutch L-45. 3. The electronics will monitor the actual rotor gear case output speed and make adjustments to the rotor drive pump as required to match the actual rotor speed to the requested rotor speed.
ROTOR OPERATING Rotor speed can be controlled in any of the 3 speed ranges. Upon the CCM3 module receiving a command speed via the CAN bus, the rotor shall accelerate hydrostatically via the pump/motor/planetary/gearbox path, disengage the Ring-to-Frame brake and engage Engine-to-Ring clutch / planetary / gearbox path. Adjustments to rotor speed, within the same speed range, may be made "on the go" either with the rotor increase/decrease rocker switch or via the Universal Display Plus monitor. An alarm instructs the operator to "shift up" or "shift down" if the rotor is commanded to a higher or lesser speed than the current range offers.
Speed range changes require the rotor to return to zero speed. Turning the separator engage switch S-30 to the OFF position disengages the Engine-to-Ring clutch and Ring-to-Frame brake, allowing the rotor to gradually return to zero RPM. Rotor speed and the command speed (Set-Point) are measured and displayed in RPMs. When the operator engages the rotor, the rotor will simply accelerate to the set-point (command speed). If the set-point speed is not attainable in the current gear range, the set speed will automatically be reset to the closest speed the current gear range can achieve. ROTOR DE-SLUG 9714 1 27/05/2004 K.40.C / 5