CROP PROCESSING - THRESHING Axial flow threshing Threshing rotor AFX (auger front) rotor - Remove (K.40.C.52.52 - F.10.A.10) AFX8010 Prior operation: FEEDING Feeder housing - Remove (K.25.E - F.10.A.10) 1. Remove the separator grate covers from each side of the combine. 2. Install the tool (1) used to secure the rotor (#380000973) by threading the bolt through the separator grate into a hole where a rasp bar bolt has been removed. Be sure the bolt has been threaded into the rotor securely, and the tool is resting against the separator grate. 10030043A4 1 3. For added security lower the concaves all the way down, and wedge a small block of wood between the rotor and the concaves.
With the block of wood in place, raise the concaves until the block is tight between the two. 4. Remove the five mounting bolts (1) and remove the front cover. 10030047B4 2 5. Mark each auger plate and rotor to insure that they are installed at the same locations. 9714 1 27/05/2004 K.40.C / 25