Case IH AFX8010 — THRESHING Axial flow threshing

CROP PROCESSING - THRESHING Axial flow threshing 6. Carefully raise the rotor up and into the combine. The rotor must be stepped into the combine, the same method as removed. For every few inches the rotor is installed into the combine, the rotor must be raised a few inches. Remove the rear support brace (1) from the rotor removal tool when the rotor is fully inserted into the tube. NOTE: Use care not to damage the cab platform with the rotor or forklift mast. 10030053A4 3 7. Install the outer coupler on the rotor with the inner coupler on the rotor gearbox. Be sure the rotor is seated in the coupler. Use a safety chain (1) when removing the tool from the rotor. 10033724A4 4 8.

Once the rotor is properly positioned in the combine, install the special tool #380000973 (1) used to secure the rotor during removal. Thread the bolt into one of the threaded holes in the rotor at the separator grates. Be sure the bolt is threaded completely into the rotor and the upper portion of the bolt is resting against the separator grate. 10030043A4 5 9. For added security lower the concaves all the way down, and wedge a small block of wood between the rotor and the concaves. With the block of wood in place, raise the concaves until the block is tight between the two. 10. Once the rotor has been secured, remove the rotor tool. NOTE:

The concave may need to be adjusted to allow the bearing plate to fit onto the rotor 9714 1 27/05/2004 K.40.C / 36