Case IH AFX8010 — THRESHING Axial flow threshing

CROP PROCESSING - THRESHING Axial flow threshing 6. Move the feeder engage switch S-31 to the ON position, and observe fuse F48. A. If the fuse is okay, continue with Step 6 . B. If the fuse immediately fails, a short to ground exists in on one of the following wires: - wire 1243 yellow, feeder engage switch connector X056 pin 6 to feeder engage diodes connector X400 pin A - wire 225 yellow, feeder engage diodes connector X400 pin B through connector X001 pin 15 to connector X018 pin J1-17 - wire 112 yellow, feeder engage switch connector X056 pin 6 through connector X001 pin 19 to connector X018 pin J1-7 Locate short and repair. 7. Key switch in "Off" position.

Check the voltage at fuse F42 using a multi-meter. A. If the voltage reading is between 10 and 18 volts , continue with Step 7 . B. If the voltage reading is less than 10 volts , there is excessive resistance between the batteries and the cab fuse panel, due to loose or corroded connections, or the batteries have discharged excessively, and are not capable of supplying the minimum voltage requirement for CCM3. Inspect the wiring from the batteries to the engine compartment, and from there to the cab. Recharge or replace the batteries. 8. Key switch ON. Move the separator switch S-30 to the ON position. Enter the Universal Display Plus "DIAG" screen.

Select the "THRESHING" or "ROTOR" sort menu, and select "CVT PMP VOLT" to check the voltage range. The proper voltage supply is 10.0 - 18.0 volts . A. If the voltage reading is between 10 and 18 volts , continue with Step 8 . B. If the voltage reading is less than 10 volts , there is excessive resistance between the fuse panel and CCM3. Inspect the following for loose or corroded connections, or damage to the wires.

- wire 109 orange, fuse F48 to relay K28, terminal 3 - wire 108 orange, fuse F48 through connector X001 pin 3 to RC harness splice - wires 110 orange & 1180 orange, RH harness splice to separator switch S-30 connector X055 pin 2 - wire 1212 yellow, separator engage switch connector X055 pin 3 to connector X012 pin J1-17 9. Start the combine engine. Enter the Universal Display Plus "DIAG" screen. Select the "VOLTAGE" sort menu, and select "CCM3 BAT" to check the voltage range. With the engine RPM at low idle, engage road and work lights. Check voltage range. The acceptable voltage range for the module is 10 - 18 volts . A.

If the voltage reading is between 10 - 18 volts , continue with Step 9 . B. If the voltage reading is less than 10 volts , the alternator and/or regulator may have failed, and the charging system is not producing sufficient voltage. Refer to Alternator - Problem solving (A.30.A.82 - G.40.A.30) for additional alternator testing information. 10. Operate the machine while observing the Universal Display Plus "DIAG" screen. A. If no low out of range readings are detected, erase the fault code and continue operation. 9714 1 27/05/2004 K.40.C / 55