Case IH AFX8010 — THRESHING Axial flow threshing

CROP PROCESSING - THRESHING Axial flow threshing A. If continuity is found, continue with Step 19 . B. If no continuity is found, the short to ground is in the grain tank jumper harness between connector X195 and connector X289 wire 696 white. Locate the short and repair. 23. Disconnect connector X004 . Use a multimeter to check for continuity between connector X004 pin 31 and chassis ground. A. If continuity is found, there is a short to ground in the cab main (CM) harness between connector X004 and the relay base for relay K-16 terminal 4 wire 695 white. Locate the short and repair. B.

If no continuity is found, there is a short to ground in the main frame (MF) harness between connector X004 and connector X195 wire 696 white. Locate the short and repair. 24. Covers do not operate in either direction. Fault code indicates an open in circuit. Disconnect the covers motor connector X289 . Measure the resistance on connector X289 between pin A and pin B. The proper resistance range for the coil is 1.0 - 5.0 ohms . A. If out of specification, replace covers motor. B. If the motor coil resistance is within specification, continue with Step 21 . 25. Replace the concave/covers relay K-16 with a known good relay. Connect X289 and operate the grain tank covers. A.

If the grain tank covers function properly, the concave/covers relay has failed. Replace the relay. B. If the covers still do not work, continue with Step 26 . 26. Disconnect the covers motor connector X289 . Turn key switch ON. Operate the covers motor using the Universal Display Plus "DIAG" screen controls. Use a multimeter to measure the voltage between connector X289 pin A and chassis ground. A. If 12 volts is found, continue with Step 27 . 27. Key switch ON. Operate the covers motor using the Universal Display Plus "DIAG" screen controls. Use multimeter to measure the voltage between connector X289 pin B and chassis ground. B. If 12 volts is not found, continue with Step 29 . A.

If 12 volts is not found, continue with Step 28 . B. If 12 volts is found, recheck the motor for continuity at Step 20 . Erase the fault codes and continue operation. 28. Disconnect connector X195 . Key switch ON. Operate the covers motor using the Universal Display Plus "DIAG" screen controls. Use multimeter to measure the voltage between connector X195 pin 3 and chassis ground. A. If 12 volts is found, the open is in the grain tank jumper harness between connector X289 and connector X195 wire 693 gray. Locate the open and repair. B. If 12 volts is not found, the open is in the main frame (MF) harness between connector X195 pin 3 and the MF wire splice wire 693 gray.

Locate the open and repair. 29. Disconnect connector X195 . Key switch ON. Operate the covers motor using the Universal Display Plus "DIAG" screen controls. Use a multimeter to measure the voltage between connector X195 pin 4 and chassis ground. A. If 12 volts is found, the open is in the grain tank jumper harness between connector X195 and connector X289 wire 696 white. Locate the open and repair. 30. Disconnect connector X004 . Key switch ON. Operate the covers motor using the Universal Display Plus "DIAG" screen controls. Use a multimeter to measure the voltage between connector X004 pin 31 and chassis ground. B. If 12 volts is not found, continue with Step 30 . A.

If 12 volts is found, the open is in the main frame (MF) harness between connector X004 and connector X195 wire 696 white. Locate the open and repair. 9714 1 27/05/2004 K.40.C / 100