CROP PROCESSING - THRESHING Axial flow threshing 6. Disconnect the main frame (MF) harness from the gearbox (GB) harness at connector X011 . Use a multimeter to check for continuity between connector X011 pin 17 and chassis ground. A. If there is continuity to ground, there is an open circuit in the gearbox (GB) harness between connector X011 and connector X428 wire 1265 blue or 1081 black/white. Locate the open and repair. B. If there is no continuity to ground, there is an open circuit in the main frame (MF) harness between connector X011 and battery clean ground #6 wire 1081 black/white. Locate the open and repair. 7.
Inspect the harness and connectors for damage, bent or dislocated pins, corroded terminals for broken wires. A. If no damage is found, erase the fault code and continue operation. 9714 1 27/05/2004 K.40.C / 131