Case IH AFX8010 — STORING AND HANDLING Grain storing

CROP PROCESSING - STORING AND HANDLING Grain storing Clean grain cross auger - Install (K.60.B.51 - F.10.A.15) AFX8010 1. To install the auger, proceed as follows: Install the auger from the left hand side by rotating the auger until it is part way into the lower elevator housing. ZDA3582A 1 2. Install sprocket and key (1) and spacer (2) on right hand end. As auger is advanced fully to the right, install right-hand side bearing (3) and tighten the nuts (do not tighten lock collar (4) at this time). NOTE:

Lubricate the spherical outer race with CASE AKCELA PREMIUM GREASE EP-2 and lubricate the locking collar track of the inner race of the bearing and the lock collar with Loctite product 767 antiseize grease to ease future disassembly. IMPORTANT: Install the auger concentric with the auger housing. 40033201A5 2 3. Adjust the auger so that the sprocket clears the divider plate in the elevator and the auger flighting clears at both ends. Tighten lock collar (4) . Install cover (5) . 4. Install the bearing and tighten nuts (1) at the left hand end. NOTE:

Lubricate the spherical outer race with CASE AKCELA PREMIUM GREASE EP-2 and lubricate the locking collar track of the inner race of the bearing and the lock collar with Loctite product 767 antiseize grease to ease future disassembly. 5. Install and tighten lock collar. Install cover (2) . Install sensor target (3) as shown or flipped over as needed to allow for clearance within sensor cover. 40033202B5 3 NOTE: Legs of target may not contact bolts or cover. 9716 1 27/05/2004 K.60.B / 20