CROP PROCESSING - STORING AND HANDLING Grain storing A. If 12 volts is found, continue with Step 12 . B. If 12 volts is not found, continue with Step 13 . 14. Key switch ON. Operate the concave motor using the Universal Display Plus "DIAG" screen controls. Use a multimeter to measure the voltage between connector X190 pin 1 and chassis ground. A. If 12 volts is not found, continue with step 15 . B. If 12 volts is found, replace the concave motor. 15. Key switch ON. Operate the concave motor using the Universal Display Plus "DIAG" screen controls. Use a multimeter to measure the voltage between connector X456 pin 1 and chassis ground. A.
If 12 volts is found, there is an open circuit in the concave extension (CC) harness between connector X190 and connector X456 wire 694 gray. Locate the open and repair. B. If 12 volts is not found, there is an open circuit in the main frame (MF) harness between connector X456 and connector X019 J2-1 wires 694 gray or 522 gray. Locate the open and repair. 16. Disconnect connector X456 . Key switch ON. Operate the concave motor using the Universal Display Plus "DIAG" screen controls. Use a multimeter to measure the voltage between connector X456 pin 2 and chassis ground. A.
If 12 volts is found, there is an open circuit in the concave extension (CC) harness between connector X456 and connector X190 wire 695 white. Locate the open and repair. B. If 12 volts is not read, continue with step 17 . 17. Disconnect connector X004 . Key switch ON. Operate the concave motor using the Universal Display Plus "DIAG" screen controls. Use a multimeter to measure the voltage between connector X004 pin 30 and chassis ground. A. If 12 volts is found, there is an open circuit in the main frame (MF) harness between connector X004 and connector X456 wire 695 white. Locate the open and repair. B.
If 12 volts is not read, there is an open circuit in the cab main (CM) harness between connector X004 and relay base terminal 4 on relay K16, wire 695 white. Locate the open and repair. 18. Disconnect connector X190 at the concave clearance motor. Use a multimeter to check for continuity between concave motor connector X190 pin 1 or 2 and chassis ground. There should not be any continuity to ground.. A. If there is continuity to ground, replace concave motor. B. If there is no continuity to ground, return to step 1 and repeat the concave motor circuit test. 19.
Manually operate the grain tank covers motor using the "DIAG" screen controls, while having an observer inspect the grain tank covers linkage for binding. A. The grain tank covers motor is bound up. See the appropriate repair manual chapter for repair. 20. The covers operates in one direction only. Fault codes indicate a short to ground. Disconnect the covers motor connector X289 . Measure the resistance on connector X289 between pin A and pin B. The proper resistance range for the coil is 1.0 - 5.0 ohms . A. If out of specification, replace covers motor. B. If the motor coil resistance is within specification, continue with Step 17 . 21.
Measure the resistance on connector X289 between pin A and chassis ground. Flex the grain tank jumper and main frame (MF) harnesses while making this check. A. If no continuity to ground is found, erase the fault code and continue operation. B. If there is continuity to ground, continue with Step 18 . 22. Disconnect connector X195 . Use a multimeter to check for continuity between connector X195 pin 4 and chassis ground. 9716 1 27/05/2004 K.60.B / 57