CROP PROCESSING - STORING AND HANDLING Grain storing Sensing system Level sensor - Open circuit (K.60.B.95.80 - G.30.B.50) AFX8010 E0159-05 - Grain Tank Full Sensor Cause: The grain bin switch (S-28 & S-29) circuit is open, or shorted to ground. Possible failure modes: 1. Switch supply wiring is open. 2. Switch signal wiring is open, or shorted to ground. 3. Grain bin 3/4 full switch S-28 is shorted to ground. 4. Controller internal failure (internal regulator failure). Solution: 1. Enter the Universal Display Plus "DIAG" screen. Select the "GRAIN HANDLING" sort menu, and select "TANK FULL SEN" to check the voltage range. The normal voltage range is 0 - 4.9 volts .
The proper voltage range with both switches neutral (tank empty) is approximately 2.5 volts . The proper voltage range with the grain bin 3/4 full switch S-28 depressed is approximately 3.3 volts . The proper voltage range with both grain bin switches depressed is approximately 3.7 volts . A. If the voltage reading is low ( 0.3 volts ) out of range, continue with step 2 . B. If the voltage reading is within the proper limits, continue the troubleshooting with step 9 . NOTE: Visually inspect the wiring harness and connectors. Verify that the connectors are fully installed. Inspect the terminals and wires in each connector for pushed back or corroded terminals or damaged wires.
Flex the harnesses involved to reveal intermittent breaks or shorts in the wiring concerned. 2. Manually move the paddle on the grain bin 3/4 full switch S-28 while monitoring the Universal Display Plus "DIAG" screen, "TANK FULL SEN" voltage. A. If the voltage remains low ( 0.3 volts ) out of range, continue with step 3 . B. If the voltage increases to approximately 2.5 volts , there is a short to ground in the grain tank (GT) harness between connector X107 pin B and connector X109 pin B wire 445 yellow. Locate the short and repair. 3. Disconnect the grain bin 3/4 full switch S-28 connector X107 . Use a multimeter to check for voltage on the harness end of connector X107 pin A.
There should be 5 volts present. A. If there is no voltage, continue with step 4 . B. If there is 5 volts present, continue with step 5 . 4. Disconnect the main frame (MF) harness from the grain tank (GT) harness at connector X009 . Use a multimeter to check for voltage on connector X009 pin G. There should be 5 volts present. A. If there is 5 volts present, there is an open circuit in the grain tank (GT) harness between connector X009 pin G and connector X107 pin A wire 440 pink. Locate the open and repair. B. If there is no voltage, there is an open circuit in the main frame (MF) harness between connector X009 pin G and connector X016 pin J2-31 wire 440 pink or wire 459 pink.
Locate the open and repair. 5. Disconnect the grain bin 3/4 full switch S-28 connector X107 . Use a multimeter to check for continuity between connector X107 pin C and chassis ground. There should be not be any continuity. A. If continuity is found, continue with step 6 . B. If no continuity is found, continue with step 7 . 9716 1 27/05/2004 K.60.B / 68