Case IH AFX8010 — STORING AND HANDLING Grain storing

CROP PROCESSING - STORING AND HANDLING Grain storing Sensing system Grain tank covers sensor - Short circuit to B+ (K.60.B.95.82 - G.30.B.54) AFX8010 E0001-03 - Grain Tank Covers Open Sensor Cause: The bin covers open sensor (B47) circuit is shorted to a higher than normal voltage source. Possible failure modes: 1. Sensor supply wiring shorted to 12 volts . 2. Controller internal failure (internal regulator failure). Solution: 1. Enter the Universal Display Plus "DIAG" screen. Select the "GRAIN HANDLING" sort menu, and select "COVERS OPEN SEN" to check the voltage range. The proper voltage for covers open - 5.6 - 7.3 volts The proper voltage for covers closed - 0.5 - 5.6 volts A.

If the voltage reading is high out of range continue with Step 2 . B. If the voltage reading is within the proper limits, since the shorted wire may not be powered up at this time. Continue the troubleshooting at Step 5 . 2. Disconnect the covers closed proximity sensor connector X288 in the grain bin. A. If the voltage drops to 7.3 - 9.0 volts the short is in the sensor, or sensor wiring. Replace the sensor. B. If the voltage remains high, continue with Step 3 . 3. Disconnect the connector X195 behind the grain bin. A. If the voltage drops to 7.3 - 9.0 volts the short is in between connector X195 and connector X288 wire 435 yellow. Locate the short and repair. B.

If the voltage remains high, continue with Step 4 . 4. Disconnect the main frame (MF) harness from the front frame (FF) harness at connector X008 . A. If the voltage drops to 7.3 - 9.0 volts , the short is in the main frame (MF) harness between connector X008 and connector X195 wire 435 yellow. Locate the short and repair. B. If the voltage remains high, the short circuit is in the front frame (FF) harness between connector X008 and connector X020 J3-38 wire 435 yellow. Locate the short and repair. 5. Operate the grain bin doors in both directions and monitor the Universal Display Plus monitor voltage readings. A.

If high voltage reading is viewed continue with Step 2 while operating grain bin doors. B. If a high voltage reading cannot be generated, erase the fault code and continue operation. 9716 1 27/05/2004 K.60.B / 74