CROP PROCESSING - STORING AND HANDLING Grain storing Sensing system Grain tank covers sensor - Open circuit (K.60.B.95.82 - G.30.B.50) AFX8010 E0001-05 - Grain Tank Covers Open Sensor Cause: The bin covers open sensor (B47) has an open circuit. Possible failure modes: 1. Sensor supply wiring is open. 2. Controller internal failure (internal regulator failure). Solution: 1. Enter the Universal Display Plus "DIAG" screen. Select the "GRAIN HANDLING" sort menu, and select "COVERS OPEN SEN" to check the voltage range.
The proper voltage for covers open - 5.6 - 7.3 volts The proper voltage for covers closed - 0.5 - 5.6 volts If there is an open in the supply the voltage will read 7.3 - 9.0 volts . A. If the voltage reading is high indicating an open continue with Step 2 . 2. Disconnect the covers closed proximity sensor connector X288 in the grain bin. Install a jumper wire between pins 1 and 2 on connector X288 . B. If the voltage reading is within the proper limits continue the troubleshooting at Step 7 . A. If the voltage drops to 0 - 0.5 volts , the open is in the sensor, or sensor wiring. Replace the sensor. B. If the voltage remains at 7.3 - 9.0 volts , continue with Step 3 . 3.
Check for continuity between pin 1 on connector X288 and chassis ground. A. If no continuity is found, continue with Step 4 . B. If continuity is found, continue with Step 5 . 4. Disconnect connector X195 . Check for continuity between connector X195 pin 2 and chassis ground. A. If continuity is found, the open is in the jumper harness between connector X195 and X288 wire 454 blue. Locate the open and repair. B. If no continuity is found, the open is in the main frame (MF) harness between connector X195 and connector X019 pin J2-14 wires 454 or 460 blue. Locate the open and repair. 5. Disconnect the connector X195 . Install a jumper wire between pins 1 and 2 on connector X195 . A.
If the voltage drops to 0 - 0.5 volts , the open is in the jumper harness between connector X195 and connector X288 wire 435 yellow. Locate the open and repair. B. If the voltage remains at 7.3 - 9.0 volts , continue with Step 6 . 6. Disconnect the connector X008 . Install a jumper wire between connector X008 pin 27 and chassis ground. A. If the voltage drops to 0 - 0.5 volts the open is in the main frame (MF) harness between connector X008 and connector X195 wire 435 yellow. Locate the open and repair. B. If the voltage remains at 7.3 - 9.0 volts , the open is in the front frame (FF) harness between connector X008 and connector X020 J3-38 wire 435 yellow. Locate the open and repair.
9716 1 27/05/2004 K.60.B / 82