Case IH AFX8010 — STORING AND HANDLING Grain storing

CROP PROCESSING - STORING AND HANDLING Grain storing Sensing system Speed sensor - Short circuit to B+ (K.60.B.95.81 - G.30.B.54) AFX8010 E0016-03 - Clean Grain Elevator Speed Sensor Cause: The clean grain elevator RPM sensor (B08) circuit is shorted to a higher than normal voltage source. Possible failure modes: 1. Sensor supply wiring shorted to 12 volts . 2. Controller internal failure (internal regulator failure). Solution: 1. Enter the Universal Display Plus "DIAG" screen. Select the "GRAIN HANDLING" sort menu, and select "ELEVATOR SPD SEN" to check the voltage range.

The proper voltage sensor blocked by ferrous metal - 5.6 - 7.3 volts The proper voltage sensor unblocked by ferrous metal - 0.5 - 5.6 volts A. If the voltage reading is high (> 9 volts ) out of range, continue with Step 2 . B. If the voltage reading is within the proper limits, the shorted wire may not be powered up at this time. Continue the troubleshooting at Step 3 . 2. Disconnect the clean grain elevator RPM sensor connector X182 . A. If the voltage drops to 7.3 - 9.0 volts , the short is in the sensor, or sensor wiring. Replace the sensor. B. If the voltage remains high, the short circuit is in the main frame (MF) harness between connector X182 and connector X019 J2-28 wire 450 yellow.

Locate the short and repair. 3. Visually inspect the harness and connectors for damage, bent or dislocated pins, corroded terminals or broken wires. A. If no damage is found, erase the fault code and continue operation. 9716 1 27/05/2004 K.60.B / 86