Case IH AFX8010 — CLEANING Primary cleaning

CROP PROCESSING - CLEANING Primary cleaning 7. Set the pin and bushing assemblies in the upper shoe frame. Turn in the four cap screws and lock washers (1) . Torque the cap screws to 150-160 Nm(111-125 lb ft) . 20013950j 4 8. Disengage the leveling frame from the positioning motor. 9. Rotate the leveling frame to make the right side accessible. Lift the shoe as necessary and install the arm clamps (1) onto the bushings. NOTE: A spacer is to be installed between the drive arm and clamp at (2) . 50013948a 5 10. Rotate the leveling frame to make the left side accessible. Repeat this procedure for the left side. NOTE: The correct orientation of the support arm is:

The end with the smaller distance between the bushing and arm surface is attached to the shoe at the top (1) . The end with the larger distance between the bushing and arm surface is attached to the frame at (2) . 11. Do not tighten the hardware until instructed. 20013949j 6 12. Lift the shoe as required and install the support arm. 13. Rotate the leveling frame to make the right side accessible. Repeat this procedure for the right side. 14. Do not tighten the hardware until instructed. 9717 1 27/05/2004 K.62.B / 57