CROP PROCESSING - CLEANING Primary cleaning 23. Connect the leveling frame (1) to the positioning motor at (2) . 40013964 10 24. Install cap screws, two washers and a locknut at (1) on both sides of the grain pan (2) . 25. Do not tighten the hardware until instructed to do so. 50013946k 11 26. Release the lock on the eccentric shaft. Rotate the shaft until the grain pan is at it’s front dead point. Adjust the right side of the pan until a distance of 12 - 16 mm ( .472 - .630 in ) is obtained between the tab on the leveling frame at (1) and the forward most point of the grain pan (2) . Bolts (1) and (2) should be tightened with eccentric shaft in the neutral position.
To achieve the 12 - 16 mm dimension, you will need to move the front seal plate up or down in its slots. The support arms can be moved fore and aft to set the 35 - 37 mm dimension. 27. Tighten all grain pan hardware. 40015724Z 12 9717 1 27/05/2004 K.62.B / 59