CROP PROCESSING - RESIDUE HANDLING Straw chopper Sensing system Speed sensor - Open circuit (K.64.C.95.80 - G.30.B.50) AFX8010 E0143-05 - Chopper RPM Sensor Cause: The chopper RPM sensor (B-10) circuit is open. Possible failure modes: 1. Sensor supply or ground wiring is open. 2. Controller internal failure (internal regulator failure). Solution: 1. Enter the Universal Display Plus "DIAG" screen. Select the "RESIDUE" sort menu, and select "CHOPPER SPD SEN" to check the voltage range. The proper voltage sensor blocked by ferrous metal - 5.6 - 7.3 volts The proper voltage sensor unblocked by ferrous metal - 0.5 - 5.6 volts The proper voltage sensor disconnected 7.3 - 9.0 volts . A.
If the voltage reading is high 7.3 - 9.0 volts , continue with Step 2 . B. If the voltage reading is within the proper limits, continue the troubleshooting at Step 7 . NOTE: Visually inspect the wiring harness and connectors. Verify that the connector was fully installed. Inspect the terminals and wires at the connector for pushed back or corroded terminals or damaged wires. Flex the harnesses involved to reveal intermittent breaks or shorts in the wiring concerned. 2. Disconnect the chopper RPM sensor connector X411 . Use a jumper wire to short the harness end of connector X411 pin 2 to chassis ground. A.
If the voltage drops to 0 - 0.5 volts indicating a ground, the open circuit is not in the supply side of the circuit. Continue with Step 4 . B. If the monitor still displays 7.3 - 9.0 volts , there is an open circuit in the main frame (MF) harness between connector X411 pin 2 and connector X016 pin J2-38 wire 413 yellow. Locate the open and repair. 3. Disconnect the chopper RPM sensor connector X411 . Use a multimeter to check for continuity between the harness end of connector X411 pin 1 and chassis ground. A. If there is continuity, the ground path for the sensor is complete, and the fault is in the sensor itself. Replace the sensor. B.
If there is no continuity, there is an open circuit in the main frame (MF) harness between connector X411 pin 1 and connector X016 pin J2-14 wire 632 blue, 425 blue or 465 blue. Locate the open and repair. 4. Visually inspect the harness and connectors for damage, bent or dislocated pins, corroded terminals or broken wires. A. If no damage is found, erase the fault code and continue operation. 9720 1 27/05/2004 K.64.C / 9