CROP PROCESSING - RESIDUE HANDLING Spreader Command valve - Unidentified failure (K.64.D.12 - G.30.B.46) AFX8010 E0053-11 - Chaff Spreader Valve Cause: The chaff spreader valve L-28 control voltage circuit open, or short to ground. Possible failure modes: 1. Supply wiring damaged. 2. Controller internal failure (internal regulator failure). 3. Bad solenoid. Solution: 1. Enter the Universal Display Plus "DIAG" screen. Select the "RESIDUE" sort menu, and select "CHAFF SPREAD VLV". Change the drop-down list to "STATUS", and use the "COMMAND" and "ENGAGE" functions to power the circuit at 100% output. The "STATUS" screen should indicate "OK" if the circuit is working properly. A.
If the status screen indicates "ERROR", the circuit is open or shorted to ground. Continue with Step 2 . B. If the status screen indicates "OK", the circuit is working properly. Continue with Step 7 . 2. Turn the key switch to the OFF position and disconnect the chaff spreader connector X235 . A. Use a multimeter to check the resistance of the chaff spreader coil. The proper resistance range for the coil is 3.0 - 7.0 ohms . If out of specification, replace coil. 3. Use a multimeter to check for continuity between connector X235 pin 1 and chassis ground. Flex the straw hood front (SW) harness while making this check. B. If the coil is within specification, continue with Step 3 . A.
If no continuity to ground is found, continue with Step 4 . B. If there is continuity to ground, continue with Step 6 . 4. Turn the key switch to the ON position. Use the Universal Display Plus "DIAG" screen controls to manually power the chaff spreader. Use a multimeter to check for 12 volts between connector X235 pin 1 and chassis ground. A. If 12 volts is not present, continue with Step 5 . B. If 12 volts is found, continue with Step 7 . 5. Key switch to the ON position. Use the Universal Display Plus "DIAG" screen controls to manually power the chaff spreader. Use a multimeter to check for 12 volts between connector X024 pin 17 and chassis ground. A.
If 12 volts is not present, there is an open circuit in the main frame (MF) harness between connector X024 and connector X019 J2-15 wire 576 white. B. If 12 volts is found, there is an open circuit in the straw hood front (SW) harness between connector X024 and connector X235 wire 576 white. Locate the open and repair. 6. Disconnect connector X024 . Use the multimeter to check for continuity between connector X024 pin 17 and chassis ground. A. If continuity is found, there is a short to ground in the main frame (MF) harness between connector X024 and connector X019 J2-15 wire 576 white. Locate the short and repair. B.
If no continuity is found, there is a short to ground in the straw hood front (SW) harness between connector X024 and connector X235 wire 576 white. Locate the open and repair. 9721 1 27/05/2004 K.64.D / 3