Case IH AFX8010 — UNLOADING Grain unloading

CROP PROCESSING - UNLOADING Grain unloading Drive system - Install (K.72.B.40 - F.10.A.15) AFX8010 20041767A5 1 1. Assemble the shaft with bearing locking collars (1) toward each other. IMPORTANT: Do not forget the washer (5) between the shear bolt hub (7) and the shoulder of the shaft. 2. Loosen bolts (1) to allow support (2) to move laterally. Set the shaft assembly (3) down in the slots of bearing supports with the flanges (4) to the inside. Install eight (8) carriage bolts with lock washers and nuts (5) . Tighten to 70 - 90 Nm ( 52 - 66 lb ft ). Loosen both locking collars to allow bearings to slide on shaft. Tighten three bolts (1) to 70 - 90 Nm ( 52 - 66 lb ft ).

Adjust shaft axially so drive sprocket (6) lines up with sliding idler (7) within 1.5 mm ( 0.06 in ) and tighten both lock collars. NOTE: If bearings or shear bolt hub are replaced, coat inside of inner race or hub with antiseize (Loctite product 767). 10030017B5 2 9723 1 27/05/2004 K.72.B / 21 1. Locking collars 4. Left bearing support 7. Shear bolt hub 2. Bearing flanges 5. Washer 8. Shear bolt 3. Right bearing support 6. Drive sprocket