DISTRIBUTION SYSTEMS - PRIMARY HYDRAULIC POWER SYSTEM STEERING CIRCUIT of the priority spool draining to the reservoir, and the increased pressure on the opposite end, the spool will shift against the spring. The priority spool will meter just enough oil to the steering circuit to make-up for the oil being bled-off through the 0.79 mm (0.031 in) orifice in the steering hand pump during low pressure standby. On the spring-end of the steering priority spool is an orifice (8) fitting that connects the steering hand pump signal line to the steering priority valve. This orifice fitting has a 0.79 mm (0.031 in) orifice in it, which serves as a dampening orifice to control priority spool movement.
Steering Priority Valve The steering priority valve is integral with the main stack valve on the left side of the combine. The primary function of the steering priority valve is to maintain a priority flow of oil to the steering system. Oil from the PFC pump is directed to the inlet of the steering priority valve. Inside the valve is the priority spool, which is spring biased. The spring will position the spool so incoming oil will to go to the steering hand pump first. When steering is not being used, pressure will increase due to the closed-center steering hand pump.
This build-up of pressure is directed to the non-spring end (12) of the priority spool through a screened 0.79 mm (0.031 in) damping orifice (11). At the same time, a screened 0.64 mm (0.025 in) dynamic sensor orifice (8) directs oil to the spring-end of the priority spool and to the signal line. The dynamic sensor orifice keeps the signal line filled with oil to keep the steering responsive. At the same time this oil is allowed to drain to the reservoir through the orifice in the steering hand pump spool.
If the oil in the signal line can flow through the steering hand pump too freely, the 0.79 mm (0.031 in) orifice in the steering hand pump will create a back pressure of 10.3 bar (50--150 psi) in the signal line. This pressure in the signal line plus the 27.6 bar (400 psi) springs in the compensator act together to put the system at low pressure standby. With the oil on the spring-side (13) The steering hand pump circuit is opened when steering is required. This will cause a pressure drop on the non-spring end of the priority spool. The spring will shift the priority spool to direct oil out to the steering hand pump. The PFC pump will stroke to meet the steering demand.
When steering demand is satisfied, pressure will start to build on the non-spring end of the priority spool. The pressure will overcome the spring, shifting the priority spool, thus allowing excess oil to be supplied to the main valve assembly if required. Threaded into the steering priority valve is a screened 0.50--mm (0.020in) orifice check. This orifice check allows oil pressure to get to the compensator when in low-pressure standby mode and when steering the combine. It also allows signal line pressure, once a function has been completed, to bleed from the compensator to reservoir through the steering hand pump, which de-strokes the pump. A.10.A / 31