DISTRIBUTION SYSTEMS - PRIMARY HYDRAULIC POWER SYSTEM STEERING CIRCUIT Steering Hand Pump AFX Series Combines use an Eaton steering hand pump. This hand pump is a closed-center, load-sensing design to minimize horsepower consumption and heat generation. The NA unit is 328 cc with 4.5 turns lock to lock and the EUR unit is 320 cc with 4.7 turns lock to lock. Two 2.25 X 13.4 cylinders are used to turn the wheels. Power Turn (left or right) Oil from the PFC pump enters the steering hand pump at the supply port. This opens the spring-loaded check valve and seats the recircula- tion check. As the steering wheel is rotated (left or right), the main spool will move within the sleeve.
This movement will direct oil to the metering section as well as to the signal line. The metering section begins to rotate with the rotation of the steering wheel. This moves oil from the PFC pump to the rod-end or the base end of the cylinder depending on the direction of rotation. At this point the oil pressure going to the cylinders is also transmitted back to the compensator by way of the signal line. Steering Neutral When there is no demand for steering, the spring-centered main spool and sleeve block the oil inlet port and the ports to the steering cylinder. At the same time the main spool and sleeve open a passage so the signal line can drain to the reservoir.
The 0.64 mm (0.025 in) dynamic sensor orifice directs oil to the spring-end of the priority spool and to the signal line. The dynamic sensor orifice keeps the signal line filled with oil to keep the steering responsive. At the same time this oil is allowed to drain to the reservoir through the orifice (1) in the steering hand pump. The orifice in the steering hand pump will create a back pressure of 10.3 bar (50--150 psi) in the signal line. This pressure in the signal line plus the 27.6 bar (400 psi) spring in the compensator act together to put the system at low pressure standby. The internal check valve between the supply and return passages is closed at this time.
Oil returning from the cylinder is directed back to the main spool and sleeve, then out the return port of the steering hand pump to the oil filter. When rotation of the steering wheel is stopped, the spring-centered main spool and sleeve return to the neutral position. This stops oil flow to the metering section and traps oil in the cylinder. A.10.A / 33