DISTRIBUTION SYSTEMS - PRIMARY HYDRAULIC POWER SYSTEM HYDRAULIC SYSTEM The reservoir tank temperature sensor monitors the oil temperature in the reservoir tank. If the temperature should climb above 128 o C (260 o F), the resistance of the sensor will be reduced to a point at which enough current will flow through it providing the CCM1 with a signal. At room temperature the sensor reads approximately 2500 ohms and reduces as the temperature increases. Electrical Monitoring Circuits The system uses a number of sensors to monitor the systems operations. HYDRAULIC FILTER RESTRICTIONS SWITCH Power is supplied to the sensor from the CCM1 connector X019 terminal J2--24 to the sensor terminal B.
The sensor terminal A is directed back to the CCM1 connector X019 terminal J2--14. Reference Material: Electrical schematic frames #10 Key Components: Hydraulic Filter Restriction Switch S--32, CCM1, ground (1) NOTE: The diagnostic screen on the Universal Display Plus monitor monitors the supply wire B. The filter restriction switch is used to monitor the condition of the filter. The switch is a N/O switch. When the pressure differential on the filter exceeds the specifications the switch piston will shuttle over connecting the power wire to the filter base, providing a ground.
The filter restriction indicator should illuminate prior to the filter by-pass opening, providing the operator time to replace the filter. RESERVOIR TANK LEVEL SWITCH Reference Material: Electrical schematic frames #10 Key Components: Hydraulic Oil Level Switch S--33, CCM2, ground (1) Power is supplied to the sensor from the CCM1 connector X019 terminal J2--34 to the sensor terminal B. The sensor terminal A is directed to the chassis ground (1). The reservoir tank level sensor monitors the oil level in the reservoir tank. If the level should fall too low the sensor will close, providing a complete circuit.
Power is supplied to the sensor from the CCM2 connector X016 terminal J2--39 to the sensor terminal B. The sensor terminal A is directed to the chassis ground (1). HYDRAULIC OIL TEMPERATURE SENSOR Reference Material: Electrical schematic frames #10 Key Components: Hydraulic Oil Temperature Sensor B--18, CCM1 Located: In the PFC pump inlet manifold A.10.A / 36