DISTRIBUTION SYSTEMS - LIGHTING SYSTEM Rear work light Wiring harness - Testing (A.40.A.17.88 - G.40.A.20) AFX8010 9668 1 27/05/2004 A.40.A / 72 N° Test Point Expected Result Other Result (Possible Cause) 1 Place Key Switch S-02 in ON position. Close Rear Work Light Switch S-43. Measure for 12 volts at Rear Work Lights Relay K-31 (pin 5). 12 volts If good reading, Go to test 2 Perform Rear Work Lights Relay Test. 2 Measure the voltage at LH Rear Work Light E-27 connector X106 (pin A). 12 volts If good reading, Go to test 3 Open circuit 652 (PU) or 67 (PU) between Rear Work Lights Relay K-31 (pin 5) and LH Rear Work Light E-27 connector X106 (pin A). 3 Disconnect the LH Rear Work Light E-27.
Measure the resistance o circuit 661 (BK) between LH Rear Work Light E-27 connector X106 (pin B) and ground. Less than 1 ohm. If good reading, replace the Rear Work Lights bulb of the LH Rear Work Light E-27. Open in circuit 661 (BK) between LH Rear Work Light E-27 connector X106 (pin B) and ground. 4 Place Key Switch S-02 in .ON. position. Close Rear Work Light Switch S-44. Measure for 12 volts at Rear Work Lights Relay K-31 (pin 5). 12 volts If good reading, Go to test 5 Perform Rear Work Lights Relay Test. 5 Measure the voltage at RH Rear Work Light E-28 connector X110 (pin A).
12 volts If good reading, Go to test 6 Open circuit 653 (PU) or 67 (PU) between Rear Work Lights Relay K-31 (pin 5) and RH Rear Work Light E-28 connector X110 (pin A). 6 Disconnect the RH Rear Work Light E-28. Measure the resistance o circuit 662 (BK) between RH Rear Work Light E-28 connector X110 (pin B) and ground. Less than 1 ohm. If good reading, replace the Rear Work Lights bulb of the RH Rear Work Light E-28. Open in circuit 662 (BK) between RH Rear Work Light E-28 connector X110 (pin B) and ground.