Case IH AFX8010 — LIGHTING SYSTEM

DISTRIBUTION SYSTEMS - LIGHTING SYSTEM Unloading tube light - Testing (A.40.A.35 - G.40.A.20) AFX8010 9668 1 27/05/2004 A.40.A / 86 F-49 Cab Fuse S-05 Seat Switch S-66 Second Seat Switch W-03 Splice Block C (backlighting) N° Test Point Expected Result Other Result (Possible Cause) 1 Place Key Switch S-02 in ON position. Activate and Unload Tube Light Relay K-32. Measure for 12 volts at Unload Tube Light Relay K-32 (pin 5). 12 volts. If good reading, the relay is operating properly. Go to test 2 Unload Tube Light Relay K-32. Adjacent circuits. Go to next test point. 2 Measure for 12 volts at Unload Tube Light Relay K-32 (pin 1).

12 volts If good reading, Go to test 3 Open or short to ground in circuit between Unload Tube Light Relay K-32 (pin 1) and CCM-1 (J1-12). 3 Measure for 12 volts at Unload Tube Light Relay K-32 (pin 3). 12 volts If good reading, Go to test 4 Open in circuit 74 (RD) between Unload Tube Light Relay K-32 (pin 3) and Fuse #50. Short to ground on circuit 77 (PU) between Unload Tube Light Relay K-32 (pin 5) and Unload Tube Light E-29 connector X105 (pin A). A short will cause Fuse #50 to blow. 4 Disconnect the Unload Tube Light Relay K-32, Measure the resistance on circuit 163 (BK) between Unload Tube Light Relay K-32 (pin 2) and ground. Less than 1 ohms.

Go to test 5 If good reading, replace Unload Tube Light Relay K-32. Open in circuit 163 (BK) between Unload Tube Light Relay K-32 (pin 2) and ground. 5 Place Key Switch S-02 in ON position. Activate Unload Tube Light Relay K-32. Measure for 12 volts at Unload Tube Relay K-32 (pin 5). 12 volts. If good reading, Go to test 6 Perform Unload Tube Light Relay Test. 6 Measure for 12 volts at Unload Tube Light E-29 connector X105 (pin A). 12 volts If good reading, Go to test 7 Open circuit 77 (PU) between Unload Tube Relay K-32 (pin 5) and Unload Tube Light E-29 connector X105 (pin A). 7 Disconnect the Unload Tube Light E-29.

Measure the resistance on circuit 669 (BK) between Unload Tube Light E-29 connector X105 (pin B) and ground. Less Than 1 ohms. If good reading, replace the Unload Tube Light bulb. Open in circuit 669 (BK) between Unload Tube Light E-29 connector X105 (pin B) and ground.