DISTRIBUTION SYSTEMS - ELECTRONIC SYSTEM Data bus - Overview (A.50.A.92 - C.10.A.10) AFX8010 20031016 1 AFX Combine CAN Data Bus Layout optional modules are shown in dotted boxes The CAN network is a multiplex system which follows the guidelines established in SAE J1939 . Multiplexing simply stated is linking two or more digital devices through a network. In the past, if an RPM sensor’s information was needed by a tachometer, an engine controller, and a transmission, all three devices would need to be hard wired to the RPM sensor. Through the CAN data bus, only one wire is needed. The information is then accessed through the network by other systems that need it.
Any other system on the network that does not care about RPM data ignores the message on the network. On today’s high tech machinery, the complexity of wiring can be greatly reduced through the use of the CAN data bus network. The network is made up of a twisted pair of wires, identified as CAN HI (yellow) and CAN LO (green). These two wires are used to form a "linear bus" network, in that the wires run in parallel from one end of the vehicle to the other, and each module is connected to both wires as a "node". These two wires are connected together at each end of the network using a 120 ohms resistor, which is known as a "termination" resistor.
Because there is a 120 ohms resistor at each end of the network, the resistance should always be 60 ohms between the CAN HI and CAN LO wires. 40031026A4 2 One termination resistor (1) is located in the right front cab post, below the shaft speed monitor (SSM). 9669 1 27/05/2004 A.50.A / 5