DISTRIBUTION SYSTEMS - ELECTRONIC SYSTEM 5. Carefully disconnect connector X016 from the bottom of the CCM2 module. Use a multimeter to check for voltage at connector X016 pin J2-31. There should be 4.5 - 5.5 volts . A. If the voltage is within 4.5 - 5.5 volts , the short is in the main frame (MF) harness on one of the following wires:
- wire 459 pink, X016 pin J2-31 to MF harness splice - wire 440 pink, MF harness splice to connector X009 pin G - wire 463 pink, MF harness splice to connector X010 pin 13 - wire 486 pink, MF harness splice to connector X011 pin 21 - wire 1199 pink, MF harness splice to connector X368 pin B - wire 1200 pink, MF harness splice to connector X445 pin 1 Carefully inspect the main frame harness between connector X016 and the grain tank, engine and gearbox harnesses for any signs of chaffing, pinch marks, or other damage which could result in an internal short. Repair any damage found. B. If the voltage is greater than 5.5 volts , there is a problem with an internal component in the CCM2 module.
Replace the module. 6. Operate the machine while monitoring the Universal Display Plus "DIAG" screen. A. If no high out of range readings are indicated, erase the fault code and continue operation. 9669 1 27/05/2004 A.50.A / 72