Case IH AFX8010 — ELECTRONIC SYSTEM

DISTRIBUTION SYSTEMS - ELECTRONIC SYSTEM Control module CCM2 - Short circuit to ground (A.50.A.91.82 - G.30.B.53) AFX8010 E0165-04 - CCM2 J2 5V Reference Context: The CCM2 J2 5V Reference circuit supplies power from connector X016 pin J2-31 through the main frame (MF) harness to several different sensors; - the air filter switch S-61 and oil pressure sensor B-52 in the engine (EN) harness, - the grain bin level switches S-28 & S-29 in the grain tank (GT) harness, - the control pressure sensor B-35 in the gearbox (GB) harness, - the tailings volume sensor R-24 and park brake pressure sensor B-53 in the main frame (MF) harness.

A short to ground on any of these supply wires will result in this fault code being displayed. Cause: The CCM2 J2 5V Reference circuit is shorted to ground. Possible failure modes: 1. Sensor supply wiring shorted to ground. 2. Controller internal failure (internal regulator failure). Solution: 1. Enter the Universal Display Plus "DIAG" screen. Select the "VOLTAGE" sort menu, and select "CCM3 J2 5V REF" to check the voltage range. The proper voltage supply is 4.5 - 5.5 volts . A. If the voltage reading is low out of range ( 4.5 volts ), continue with Step 2 . B. If the voltage reading is within the proper limits, continue the troubleshooting at Step 6 . NOTE:

Visually inspect the wiring harness and connectors. Verify that the connector was fully installed. Inspect the terminals and wires at the connector for pushed back or corroded terminals or damaged wires. Flex the harnesses involved to reveal intermittent breaks or shorts in the wiring concerned. 2. Disconnect the grain tank (GT) harness from the main frame (MF) harness at connector X009 . A. If the voltage increases to 4.5 - 5.5 volts , the short is in the grain tank (GT) harness between connector X009 pin G and connector X107 pin A wire 440 pink. Locate the short and repair. B. If the voltage remains low, continue with Step 3 . 3.

Disconnect the gearbox (GB) harness from the main frame (MF) harness at connector X011 . A. If the voltage increases to 4.5 - 5.5 volts , the short is in the gearbox (GB) harness between connector X011 pin 21 and connector X098 pin B wire 486 pink. Locate the short and repair. 4. Disconnect the engine (EN) harness from the main frame (MF) harness at connector X010 . B. If the voltage remains low, continue with Step 4 . A. If the voltage increases to 4.5 - 5.5 volts , the short is in the engine (EN) harness on one of the following wires:

- wire 463 pink, connector X010 pin 13 to engine harness splice - wire 469 pink, engine harness splice to connector X330 pin B (air filter resistor R15) - wire 490 pink, engine harness splice to connector X197 pin 5 - wire orange, connector X197 pin 5 to oil pressure sensor connector X337 pin B Locate the short and repair. 9669 1 27/05/2004 A.50.A / 80