Case IH AFX8010 — PRIMARY HYDRAULIC POWER SYSTEM

DISTRIBUTION SYSTEMS - PRIMARY HYDRAULIC POWER SYSTEM Lubrication System The lubrication system is used to provide cooling and lubrication to the PTO gearbox and all components housed with in it. The system consist of a lube pump, pump relief, lube filter, oil cooler, lube relief and required plumbing. The pump and pump relief is enclosed in the ground drive hydrostatic pump, we would think of them as the hydro charge pump and charge pressure relief. air screen and is the upper section of the first layer of coolers. The lube regulating valve (7) limits the maximum lube pressure in the system. The minimum lube pressure will be determined by the output of the lube pump.

The pressure may be monitored on the Universal Display Plus monitor from the pressure sensor at port (8). If the lube pump relief (3) valve opens the flow is dumped into the ground drive hydro. pump and directed out the pump case drain. The relief protects the pump, filter and cooler from being over pressurized. The cooler is located behind the rotary The ground drive hydrostatic motor case drain (13) is monitor for temperature before it enters the return manifold. The motor case drain should be the hottest return oil in the system. A.10.A / 54