POWER PRODUCTION - ENGINE section of figure above), a four-digit number represents the coupling number of the crankcase with its respective sub-crankcase, the following seven digits, taken singly, represent the class of diameter of each of the main bearing seats to which they refer (bottom section of figure above) and each of these digits may be 1, 2 or 3. 280820031399055 5 Main journals and crankpins: determining the class of diameter of the pins. Three sets of figures are marked on the crankshaft, in the position shown by the arrow (top of figure shown above):
the first number, comprising five digits, is the serial number of the shaft; underneath this number, on the left, a set of six digits refers to the crankpins and is preceded by a single digit, which indicates the status of the pins (1 - STD, 2 = -0.127 [0.0050"]), the other six digits, taken singly, represent the class of diameter of each of the crankshafts to which they refer. The set of seven digits on the right side refers to the main journals and is preceded by a single digit, which indicates the status of the pins (1 - STD, 2 = 0.127 [0.0050]).
The other seven digits taken singly represent the class of diameter of each of the main journals to which they refer (bottom of figure shown above). 280820031400886 6 9671 1 27/05/2004 B.10.A / 19