POWER PRODUCTION - ENGINE The crankshaft front and rear sealing rings are the Rotostat sliding type. The rings take the form of a washer (1) , fitted directly onto the crankshaft, a sealing lip (2) and a case (3) , fitted into a seat on the front cover or flywheel cover case. This type of seal offers the advantage of creating a seal on the washer (at point (4) ), instead of directly on the shaft. This type of seal is more effective, because it is not affected by side-to-side shaft movements and the shaft itself does not become grooved. Special tools must be used to remove and refit these seals. 9671 1 27/05/2004 B.10.A / 36