POWER PRODUCTION - ENGINE ENGINE - Disassemble (B.10.A - F.10.A.25) AFX8010 1. Protect or cover engine electrical parts before washing the engine with a high-pressure washer. Before securing the engine on the rotary stand, remove the electric cable from the engine, disconnecting it from the control unit and from all the sensors/transmitters to which it is connected. With an appropriate tool (1) , turn in the direction of the arrow on the tightener and remove the fan belt (2) from the fan (3) . Remove the compressor, together with the engine mount. 50034738A5 1 2. Remove the oil pressure adjustment valve (1) . mid0278a 2 3. Drain off the coolant from the engine cooling system.
Using a suitable tool (3) , turn in the direction of the arrow on the tightener (2) and remove the drive belt (1) . Take out the fixing screws and remove the water pump (5) . For refitting, reverse the removal operations, fitting a new ring seal on the water pump and tightening the fixing screws to the required torque, as noted in Water pump - Torque (B.50.A.20 - D.20.A.10) . To remove the thermostat, remove the fixing screws and disconnect the thermostat box (4) . Reverse this step if replacing the thermostat and install a new gasket. Upon completion, fill the cooling system with the required type and amount of coolant. MID0498B 3 9671 1 27/05/2004 B.10.A / 44