POWER PRODUCTION - ENGINE Valve drive - Measure (B.10.A.40 - F.40.A.16) AFX8010 IMPORTANT: Handle all parts carefully. Do not put your hands or fingers between parts. Wear suitable safety clothing - safety goggles, gloves and shoes. 1. The surfaces of the supporting pins of the shaft and those of the cams must be extra smooth. If they show any sign of seizing or scoring, replace the shaft and the relevant bushings. 2. To check cam lift and pin alignment, place the camshaft (4) , on the v-block centers (1) and using a dial gauge (2) , check that the lift of the cams (3) , corresponds to the values given in Valve drive - Dimension (B.10.A.40 - D.40.A.30) . mid0456a 1 3.
Again, with the camshaft (4) , on the v-block centers (1) , using a dial gauge (2) , check the alignment of the supporting pins (3) ; it must be no greater than 0.020 mm ( 0.0008 in ). If there is any greater misalignment, replace the shaft. mid0457a 2 4. To check the assembly clearance, measure the inside diameter of the bushings using a micrometer (1) and the diameter of the pins of the camshaft. The difference will give the actual clearance. If the clearance is greater than 0.160 mm ( 0.0063 in ), replace the bushings and, if necessary, the camshaft as well. mid0458a 3 9671 1 27/05/2004 B.10.A / 57