POWER PRODUCTION - ENGINE Cylinder block - Replace (B.10.A.70 - F.10.A.30) AFX8010 1. Position the parts (2) and the plate (4) , of tool 380000366 , as shown in the figure, checking that the plate (4) , rests correctly on the cylinder liner. Screw down the nut of the screw (1) and extract the cylinder liner (3) , from the crankcase. 2. Always replace the water ring seals (3) , (4) and (5) . Fit the adjustment ring (1) on the cylinder liner (2) . Lubricate its bottom portion and fit it in the cylinder assembly with an appropriate tool. mid0387a 1 IMPORTANT: The adjustment ring (1) , is supplied as a spare in the following thicknesses: 0.08 mm - 0.10 mm - 0.12 mm (0.003 - 0.004 - 0.005 in). 3.
Check the protrusion of the cylinder liners with tool 380000140 , (2) and tightening the screw (1) , to the torque of 220 Nm ( 162 lb ft ). Measure with the dial gauge (3) , that the protrusion of the cylinder liner from the supporting surface of the cylinder head is the X value, as noted in Cylinder block - Dimension (B.10.A.70 - D.40.A.30) 20040341 2 mid0389a 3 9671 1 27/05/2004 B.10.A / 96