POWER PRODUCTION - ENGINE Cylinder head - Disassemble (B.10.A.72 - F.10.A.25) AFX8010 1. To remove the valves, secure the tool, 296173-296174 (2) , with the bracket (4) , to the cylinder head. Screw down with lever (1) , until it is possible to remove the cotter pins (3) . Remove the tool (2) and extract the top plate (5) , spring (6) and bottom plate (7) . Repeat this process for all of the valves. Turn the cylinder head over and extract the valves (8) . 2. Before replacing used camshaft bearings, inspect them closely. The surfaces of the bushings must not show any signs of seizing or scoring. If they show any signs of damage, they must be replaced.
Using a bore gauge, measure the inside diameter of the bushings. If it is above the tolerance value, replace the bushings (see Valve drive - Dimension (B.10.A.40 - D.40.A.30) ). To disassemble and reassemble the bushings of the camshaft, use the drift: 296188. A. Drift; B. Bushing positioning grub screw; C. Reference for fitting the 7th bushing; D. Reference for fitting bushings: 1 - 2 - 3 - 4 - 5 - 6, reference mark for the F2B engine, red mark for the F3A engine; E. Guide bushing; G. Guide bushing to secure to the 7th bushing mount; H. Plate for securing bushing G to cylinder head; I. Grip, and L. Extension coupling. mid0446a 1 MID0442A 2 IMPORTANT: Handle all parts carefully.
Do not put your hands or fingers between parts. Wear suitable safety clothing - safety goggles, gloves and shoes. 3. The valve guides are removed with drift 296153. Assembly is performed with drift 296153 equipped with part 296178. IMPORTANT: Part 296178 determines the exact position of assembly of the valve guides in the cylinder head. If they are not available, it is necessary to drive the valve guides into the cylinder head so they protrude from it by 31.3 - 31.7 mm ( 1.232 - 1.248 in ). mid0498a 3 9671 1 27/05/2004 B.10.A / 98