Case IH AFX8010 — FUEL AND INJECTION SYSTEM

POWER PRODUCTION - FUEL AND INJECTION SYSTEM Fuel injector - Static description (B.20.A.29 - C.30.A.20) AFX8010 The new Bosch PDE 30 electronically controlled fuel pump injectors can achieve higher injection pressures than conventional systems with a separate pump and external piping. The electronic injection management (EDC) already applied to some conventional engine versions is similar in basic layout, but the new system is much more sophisticated and differs in many respects, e.g. individual management of each individual injector and advanced fault diagnostics function built into the electronic control unit.

The MS6 electronic control unit also manages many other systems, including turbocharging.Electronic Control Unit: To reduce the number of connections, the length of injector connection leads and hence signal interference, the control unit is fitted directly onto the engine via a heat exchanger (used for cooling) by means of flexible blocks which reduce vibrations transmitted by the engine. A internal environmental pressure sensor further improves injection system management. The control unit is equipped with a highly advanced self-diagnostic system.

It is able to take environmental factors into consideration in order to detect and store anomalies (even if intermittent) occurring within the system during vehicle operation to ensure more effective, reliable repairs. The MS6.2 electronic control unit manages the following main functions: fuel injection, accessory functions, self-diagnosis and recovery. It also permits: interface with other on-board electronic systems EOL and Service programming and fault diagnosis. 20034773.tif 1 The pump injector consists mainly of three parts: solenoid (1) , pumping element (2) and nozzle (3) . These three parts cannot be individually replaced and cannot be serviced.

The pumping element is operated mechanically upon each cycle by a rocker. It compresses the fuel in the delivery chamber. Nozzle configuration and operation are similar to those of conventional injector nozzles. It is opened by fuel under pressure to inject a fine spray of fuel into the combustion chamber. The solenoid is controlled directly by the electronic control unit and determines delivery mode on the basis of a control signal. An injector case houses the lower part of the pump injector in the cylinder head. 9672 1 27/05/2004 B.20.A / 14