DISTRIBUTION SYSTEMS - PRIMARY HYDRAULIC POWER SYSTEM # 5 Control Pressure Test This test is used to determine the control pressure relief valve setting. The control pressure relief valve is set to provide an operating pressure of 20--22 bar (290--320 psi). The relief is located in the valve body. If adjustment is needed, loosen the jam nut and using an allen wrench turn the center screw in to increase pressure and out to decrease pressure. After the adjustment has been made, the test should be repeated to verify the spring setting. NOTE: This can be checked on the Universal Display Plus monitor by placing the “Control Pressure” on one of the RUN screens. NOTE:
Activate all associated clutches and hydrostatic drives to determine if any circuit has excessive leakage. The pressure MUST be maintained during clutch and hydro. activation. The pressure will normally be on the low side when the engine is low idle. Test Procedure Attach a 41 bar (600 psi) gauge to the control pressure DIAG port located on the Control Pressure/Lubrication Valve. With the engine at HIGH idle the pressure reading should be within specification. IMPORTANT: Do NOT exceed 25 bar (360 PSI) with cold oil, there should be approximately 20 bar (290 psi) at high idle with hot oil and all systems running. A.10.A / 70