DISTRIBUTION SYSTEMS - PRIMARY HYDRAULIC POWER SYSTEM # 6 PTO Gear Box Lubrication Pressure Test This test is used to determine the lube pressure relief valve setting. The lube pressure relief valve is set to provide an operating pressure of 3.4 bar (50 psi). 2. If the machine’s software has been updated it may be monitored on the Universal Display Plus monitor RUN screen after placing the item on one of the RUN screens. NOTE: This can be checked on the Universal Display Plus monitor by placing the “Lube Pressure” on one of the RUN screens. On some of the earlier machine there may be a test fitting in place of the sensor, in that case the pressure gauge will have to be used.
Attach a 41 bar (600 psi) gauge to the lube pressure DIAG port located on the Control Pressure/Lubrica- tion Valve. With the engine at LOW idle the pressure reading should be within specification, check at HIGH idle to verify operation. The relief is located in the valve body. The cartridge is NOT adjustable, if pressure is not correct the lubrication pump should be flow rated to verify it can produce the proper flow and pressure. If the pump is operating properly replace the LUBE regulating valve. Test Procedure Pressure may be tested by two different methods: 1. Remove the lube pressure sensor from the CONTROL/LUBE control valve and install a test fitting. A.10.A / 72